SEED SPLITTING BOOTS

FEATURES

  • System has 2 main parts holder & splitter boot.
  • Splitter Boot compatible with 12” and 10” spacing’s machines.
  • Suitable for Series 2, 3 & 4 machines
  • Highest quality tungsten carbide used on all groundhog splitter boots.
  • Places seed into the wall of the trench in the moisture zone. Helps to combat non wetting soils and seed depth problems in the knife slot where the soil may also be dry.
  • No loss of seed to the bottom of the knife furrow.
  • Seed is sown into uncultivated soil and the moisture zone.

SERVICE TIP:

n for easy removal. To save time remove pins using side cutters or a hammer to shear off pin. Replace with a new pin.

Underside Profles:

FEATURES

  • Priced competitively
  • Leading tungsten tile at a reverse angle to help ride over obstacles.
  • Low profle for minimal soil throw
  • Suited to 70mm-90mm press wheel
  • Design Reg: 364181

FEATURES

  • Leading tungsten tile at a reverse angle to help ride over obstacles.
  • Heavy duty tungsten applied to each wing
  • Specifc draft angle to reduce drag & friction
  • Thick underside base
  • Suited to 70mm-90mm press wheel
  • Extra tile of tungsten added to top of each wing
  • Design Reg: 201714877

FEATURES

  • Leading tungsten tile at a reverse angle to help ride over obstacles.
  • Alternate profle to suit heavy duty conditions
  • Inverted base / rounded middle section closes the knife trench ensuring seed separation
  • Compatible with 70mm press wheel, best suited to 90mm+

Splitter Boot results: